- Seradanmo right angles to the cutting edge parts, and tools to make the mold down stage.
Mold has fallen so far made to stage the pain while using the jig, easy to clean as possible
Concept can be designed.
- 0.8 according to the scale and character models can be selected for the 0.4 mm-mm blade.
Flat part of the cliff top can also be used as a normal Kanna.
- Create a mold used to step down parts of the character models.
By making a mold seam down the common stage, you feel much better.
- Using it is simple.
To rely on the edge of the blade part, we will lower the blade perpendicular to the guide protrusion of the tip.
This time will vary by the amount that can be cut down so the blade angle and put in force.
The trick is to gently shave more than once.
- And swerved into the blade and the power to mold a beautiful step down or increasing amounts to a partial cut
Be. Note that the hard part, especially at both ends were cut.
- When will increase accuracy, BMC sharper the drill steel and the mold design knife.
Chatters who care about the fine and go to the more beautiful silky finish lightly with water-resistant paper.
- If mold is made to the fall of the curve increases the difficulty of the stage.
Because they deviate at the edge of the curve once you dig in like a straight line.
Digging with a favorite phrase that makes it difficult to recover it once and would like Sujibori.
To prevent it, digging with a short (generally less than 1cm), how useful will tie together.
A constant amount of drill for a short distance arrive favorite phrase is some digging, we'll trace the whole.
- Who had been recommended to make a hard mold to step down now.
- It is recommended for those who may seek to design a notch character models.
- Recommended for those who prefer the delicate task than anyone else.
( This is a machine translation. Please allow for possible misinterpretations in the text. )