- A luxurious kit that includes EZ tracks, aluminum barrels, and 3D printed parts
- This is a 1/35 scale plastic model assembly kit of the German World War II half-track Sd.Kfz.251C equipped with a 7.5cm gun, known as the Hanomag.
- This kit includes EZ tracks, aluminum barrels, 3D printed parts, and more to enhance the realism of the finish.
[About the actual car]
- One of the half-tracks deployed and used by the German army during WWII was the Sd.Kfz.251.
- The Sd.Kfz.251 is an armored personnel carrier developed based on a 3-ton half-track. It was used to tow various types of artillery, and many derivatives were also made.
- Among them, the Sd.Kfz.251/9 is a fire support vehicle equipped with a 7.5cm KwK37 tank gun, which is also mounted on tanks.
- The body was the C type, and the final production type, the D type, which was produced in 1943 and simplified in order to improve productivity.
- The basic type of troop carrier is equipped with a Maybach HL-42 inline 6-cylinder engine and has a top speed of approximately 50 km/h.
- It was equipped with one 7.92mm machine gun at the front and one at the rear in the open-top troop compartment.
- They continued to fight alongside the armored divisions as soldiers' feet until the end of the war.
[About the model]
- The model is a 1/35 scale plastic model assembly kit that reproduces the armored personnel carrier, Sd.Kfz.251 early production type, Sd.Kfz.251/9 Ausf.C 7.5cm KwK37 mounted on a C-type chassis.
- The 7.5cm gun mounted on the vehicle is the same as that used in the Sturmgeschütz III, giving it an impressive finish.
- The short-barreled main gun is made of machined aluminum parts, and the inside of the barrel is engraved with rifling.
- In addition, 3D printed parts are used for the main gun base, giving it an even sharper finish.
- The vehicle body faithfully models the complex design of the Sd.kfz251C type vehicle exterior with a total length of approximately 165mm.
- The open-top troop compartment is also reproduced in detail, with gun racks and radios modelled.
- The chassis uses EZ Tracks for ease of assembly.
- This kit includes 3D printed parts to enhance realism.
[Major features]
- 1/35 scale reproduction of the German Sd.Kfz.251/9 Ausf.C equipped with a 7.5cm gun
- The finished length is approximately 165mm and the tracks are EZ Track.
- The barrel is a machined aluminum part with rifling engraved on it.
- 3D printed parts are set for the main gun base etc.
- The tracks are assembled using EZ tracks.
( This is a machine translation. Please allow for possible misinterpretations in the text. )