--Made by 3D printer
--1/48 Connected movable tracks for Tiger I
[What is a connected movable track? ]
-It is a track kit that was output in a connected state from the beginning, and it becomes a movable track just by removing the support material.
――In CHINOMODEL, in order to leave the restrictions of hardware and [fun to make], it is not a state where all are connected, but a method to create several chunks of about 2 to 30 pieces and individual tracks for adjustment. I am taking.
[Notes on connected movable tracks]
――As a characteristic of this product, in order to prevent the crawler plates from completely adhering to each other, the gap between the crawler plates is larger than that of the normal connected movable crawler belt. Therefore, the interval is extended, and the length is just right with a smaller number than the general number.
――Structurally, it is not strong enough to withstand violent movements. note that.
――Because it is easy to come off, please handle it with care.
--Avoid work processes that allow a large amount of solvent or moisture to flow in. The material becomes soft and can easily be damaged.
[Notes specific to this product (CM-039S)]
――Since it has a slight restoring force like a rubber track, it is recommended to partially bond it after winding.
――Therefore, it is not suitable for storage in a movable state or for use as an RC model.
――The purpose is to simplify the assembly / painting process and reproduce the slack.
* This product is unassembled and unpainted.
* Please prepare a 0.3 mm metal wire separately. As standard, it is necessary to connect 4 times on each side.
[Conformity confirmed kit]
--Tamiya Tiger I series 2 lumps on each side + 2 sheets (96 sheets)
--Made in Japan
( This is a machine translation. Please allow for possible misinterpretations in the text. )